Original Article
Parameters optimization in chromatography purification of human immunoglobulin for intravenous injection
Li Guanjun, Zhang Xuecheng, Zhang Jiantao, Liu Yafang, Luo Jian
Published 2019-06-10
Cite as Int J Biologicals, 2019,42(3): 125-128. DOI: 10.3760/cma.j.issn.1673-4211.2019.03.006
Abstract
ObjectiveTo optimize application conditions of anion exchange chromatography medium in purification of human immunoglobulin for intravenous injection (IVIG) using the response surface method, and to establish the best chromatographic parameters.
MethodsTwo-factor, 3-level response surface method was used to design the chromatographic parameters pH and conductivity. Biuret method and high performance liquid chromatography were used to determine the protein concentration and the molecular size distribution, respectively. The protein recovery rate and the content of dimer plus monomer were used to evaluate the effect of purification under different parameters. The optimized chromatographic parameters obtained were then verified.
ResultsOptimized conditions of chromatography purification static balance and sample loading were pH5.4 and conductivity 1.05 mS/cm. Under this chromatography condition, using plasma fraction Ⅱ as raw material, protein recovery was (96.6±3.1) %, IgG dimer plus monomer ratio was (99.98±0.02)%, IgA content was (2.6±1.1) mg/L and IgM content was (4.5±1.4) mg/L.
ConclusionAnion exchange chromatography optimized by the response surface method can be used for the preparation of IVIG from plasma component Ⅱ.
Key words:
Human immunoglobulin for intravenous injection; Anion exchange resins; Response surface method
Contributor Information
Li Guanjun
Research and Development Center, Hualan Biological Engineering Inc., Xinxiang Henan 453003, China
Zhang Xuecheng
Research and Development Center, Hualan Biological Engineering Inc., Xinxiang Henan 453003, China
Zhang Jiantao
Research and Development Center, Hualan Biological Engineering Inc., Xinxiang Henan 453003, China
Liu Yafang
Research and Development Center, Hualan Biological Engineering Inc., Xinxiang Henan 453003, China
Luo Jian
State Key Laboratory of Biochemical Engineering, Institute of Process Engineering, Chinese Academy of Sciences, Beijing 100190, China
